Tactical shotgun "M4" Red Dot - 1/12 scale

***PLEASE NOTE***

Action figure scales vary widely. We try to hit the Classified 1/12 and the McF/Mythic 1.0 scales. Please use photo references with figures for sizing. You are responsible for choosing the best size pieces for your figure. Js Armory does not accept returns for mistakes in size. IF you are in doubt if it will fit, please send us a message and we will assist you in your purchase. Thank you.

****READ ABOVE****

3d printed GI Joe Classified compatible 1/12 scale Tactical Shotgun M4

Printed in Resione Tough K+ resin

Designed by 3ddios

Disclaimers and instructions:

If you have any issues, please send me a message! :)

Heads will need to be fitted for the figure you choose. You can get away with sticky tack on the ball peg but a more permanent solution is best. Dremeling, putty, etc may be needed to ensure a proper fit. I use a method that utilizes hot glue. Use petroleum jelly on the neck peg. Fill the head hole with enough glue to push the peg into the head and some of the glue to squeeze around the neck ball. As it dries, continue to move the neck peg so it will not bind in the hole.

NO FIGURES ARE INCLUDED. ONLY THE KIT ITEMS.

For best results, permanently glue the belt/harness at their connectors the body.

Please handle with care. Gently warm the harness in with a hair dryer if needed to shape. CAREFULLY as to not damage the item or paint. Shape harness to figure and cool in water or glue to hold into place.

There will be differences and imperfections in each piece including small flaws in prints. I strive to make quality items. Please understand that these are more fragile than a manufactured item. Please handle them with care.

Wearable items are made with Siraya Tenascious 75/25 mix to provide strength and flexibility. If you purchased pre-painted items, the paint may cause the item to be more rigid. You may need to heat items and shape them to your liking (Hot water may be the safest method). Most vests will need this to fit properly and fasten onto a figure. Once in place, I recommend gluing the connectors.

Thank you so much for considering a purchase!
All hand-painted items present the chance of paint rub. Either the paint off the item or the paint off the item onto the figure. This isn't very common with the finish I use, but it has happened. Please handle the items with care. If placing a vest onto a figure and it needs to be shaped first, please warm it slowly with a hair dryer. Thank you!